Taylor Made Products Trailerite Semi-Custom Boat Cover for Walk-Around Cuddy Cabin Boats with Inboard/Outboard Motor - Waterproof & UV Resistant Protection for Boats 18-22 ft - Ideal for Outdoor Storage & Trailering

Fits good and seems to be pretty tough. There is a re-enforced panel where it goes over the upper windshield on my cuddy cabin. My boat is 19ft and this seems to fit just fine. A little long. A little wide, but with the high rails that actually works out to make sure that walk around deck area is covered as well. A slightly smaller one I had did not cover this area very well. the strap material that comes with it has to be cut to length. Also you get a bag of parts for tie downs that you have to assemble yourself. This was easily done and provides a bit of a custom fit. There was plenty of material. Of course you need to make sure that all sharp edges have been covered. I have made these little leather boots that go around the corners of my windshield, otherwise it will tear there after some use even with the re-enforcing. This is my 3rd taylor made cover. I typically get 3 years out of my covers. Outdoors storage with lots of sun and heat on the west side of the house. Also wind, rain, snow, etc. Couple hundred every 3 years is less expensive than a boat slip or offsite storage.not sure what happened, the fabric does it's job but with in a year and half the back panel ripped. a big old rip about 18 inches long. looks like it came apart. said it had a 5year warrenty. it is not even in a spot that has a lot of tension on it. very bummed about it. the cover fitted good. didn't allow any water penetration. going to need a new one now.This cover was perfect for my walk-around cuddy cabin boat. Seems well made, includes all necessary straps, etc. You have to cut the straps to length yourself, but there was plenty of material.